MITSUBISHI MG460 GRADER PARTS

MG460 Parts for Powertrain and Blade-Control Repairs

The MG460 is commonly repaired as a system rather than as a collection of isolated components because drivetrain response and blade accuracy depend on several connected assemblies. Vomeks helps buyers structure the request around the failed function, verify the installed part and obtain a commercial quotation suitable for export purchasing.

Function-based sourcing: parts can be reviewed according to drive, steering, blade rotation or cylinder symptoms.
Machine-reference control: serial data and component markings are used to reduce cross-model selection errors.
Overhaul coordination: gears, shafts, bearings, seals and related hardware can be checked as a repair group.
Commercial alternatives: available OEM and aftermarket options can be compared before order confirmation.
International fulfillment: shipment size, destination and urgency are considered during quotation preparation.

DESCRIBE YOUR MG460 FAILURE

Tell us what the operator noticed immediately before the fault and which functions remain normal. A symptom sequence can be more useful than a general statement such as “hydraulic problem” or “transmission problem.”

Brand: Mitsubishi | Equipment Type: Motor Grader | Model: MG460 | Service: Part identification, quotation and worldwide supply

From MG460 Symptom to Purchasing List

A useful request connects the operator report with the workshop inspection. Loss of a single blade movement suggests a different path from slow response across all functions, while a noise appearing only under load can guide attention toward specific gears, bearings or shafts. This information helps convert diagnosis into a targeted parts quotation.

Select the MG460 Functional System

Open the relevant model-specific page for transmission, hydraulics, axle, circle drawbar, tandem, cylinders or circle reverse gear. The links keep each technical request attached to a clear purchasing category.

TURN THE MG460 DIAGNOSIS INTO A QUOTE

Overheating in the Powertrain

Transmission temperature rising during loaded travel may be associated with slipping elements, restricted oil flow or internal wear. Note the operating time before overheating, whether drive quality changes and what material was found in the oil or filter.

Uneven Circle Rotation

Jerky or tight rotation can result from tooth damage, support wear, contamination or alignment issues. Photos taken at several circle positions and a description of where resistance occurs can help identify whether the request should focus on the reverse gear, circle components or drawbar supports.

Hydraulic Valve or Cylinder Decision

External oil at a cylinder does not automatically prove that the cylinder is the only cause of poor movement. Confirm whether the rod is damaged, whether the function creeps under load and whether another circuit behaves normally before requesting a seal kit or complete component.

Checking Mating Parts During Overhaul

Whenever a worn gear, shaft or bearing is removed, inspect the contact surfaces that supported it. Quoting only the visibly failed MG460 part may save cost initially but can lead to rapid damage if the mating condition is ignored.

Visit the Mitsubishi motor grader page to coordinate requests for adjacent MG models in the same fleet. Mitsubishi Motor Grader Parts